Kitchen
Dishwasher Smells Bad: Where the Odor Comes From and How to Kill It
A sour or sewage smell from the dishwasher is usually food debris, a blocked drain, or a dry trap. Five causes and a cleaning routine that works.
A dishwasher that smells like a drain is not just unpleasant; it usually means food debris is sitting somewhere it should not. The smell transfers to dishes, and people start rinsing everything twice, which wastes water and does not fix the source.
The odor has a location. Sour and mildew smells come from the filter and the sump. Sewage smells come from the drain path or a dry trap. Chemical smells come from detergent residue or a rinse aid problem. Find the location first.
Before you touch anything
Unplug the dishwasher or turn off its breaker before reaching into the sump. The heating element and the pump are down there.
Do not run a cycle with bleach in the tub if the machine has a stainless interior; repeated bleach use corrodes stainless. Use vinegar or a dishwasher cleaner instead.
If the smell is sewage and the sink next to it also drains slowly, the problem is the drain line, not the dishwasher. Stop and address the drain.
1. The filter and sump hold rotting food
The filter catches food, and the sump below it holds a little water between cycles. If the filter is not cleaned, that debris decays. This is the most common cause of a sour smell, and it is free to fix.
How to test it: Remove the bottom rack and lift out the filter. Smell it. If the odor is concentrated there, you have found it.
What it means: Rinse the filter under hot water and scrub the sump with a brush. Then run a hot cycle with a cup of white vinegar in the bottom of the tub. Clean the filter monthly from then on.
2. The drain hose or the air loop is blocked
The drain hose carries water out, and on many installations it runs through an air loop or a high loop to prevent backflow. Food and grease collect in the hose, and dirty water from the sink can siphon back into the dishwasher if the loop is missing.
How to test it: Look at the drain hose under the sink for a kink or a low sag. Check whether the hose is looped above the trap. A hose lying flat on the cabinet floor holds dirty water.
What it means: Clear the hose, and make sure it loops high. If the disposal has a dishwasher inlet, check that the plug was knocked out when the dishwasher was installed; a plugged inlet traps water.
3. The sink trap or the disposal is the source
A dishwasher shares a drain path with the sink. A dirty disposal, a clogged trap, or a slow sink drain produces odors that appear every time the dishwasher runs.
How to test it: Run the disposal with water and smell the drain. If the sink smells, the dishwasher is innocent.
What it means: Clean the disposal with ice and citrus peel, or use a disposal cleaner. Clear the trap. This is the fix for most “sewage smell” complaints.
4. Water is sitting in the tub after a cycle
A dishwasher that does not fully drain leaves water at the bottom, and that water grows bacteria. You will see it when you open the door after a cycle.
How to test it: Open the door mid-cycle and at the end. Water standing at the bottom after the drain phase means the pump or the drain path is restricted.
What it means: Check the filter, the drain hose, and the pump for debris. If the pump runs but does not empty, the pump impeller or the check valve is the cause. See dishwasher won’t drain.
5. The door gasket and the corners collect residue
The door gasket seals the tub, and food and detergent collect in its folds. The corners of the tub and the area around the detergent dispenser are also common spots for residue that turns sour.
How to test it: Run a damp cloth along the gasket and smell it. A dark film in the folds is the source.
What it means: Wipe the gasket after each load, and clean it weekly with a vinegar solution. A gasket that is cracked or moldy beyond cleaning should be replaced.
6. Cold washes and eco cycles leave grease behind
Washing everything on a short eco cycle at low temperature does not dissolve fats fully. Grease accumulates on the tub walls and the filter, and it goes rancid.
How to test it: Look at the tub walls after a cycle; a slippery film means grease is building. Check whether you have been running only eco cycles for months.
What it means: Run a hot cycle with a dishwasher cleaner once a month, and use a normal cycle for greasy loads. This is maintenance, not a repair.
Quick diagnosis table
| The smell | Most likely cause | Effort |
|---|---|---|
| Sour, strongest at the bottom | Filter and sump debris | Free |
| Sewage, appears only when the dishwasher runs | Sink trap, disposal, or drain hose | Low |
| Sewage, also slow sink drain | Shared drain line | Plumber |
| Water left in the tub | Drain restriction | Low to medium |
| Musty, strongest at the door | Door gasket residue | Free |
| Greasy film on the tub | Cold washes, no hot cycle | Free |
When to stop and call a technician
Call if water remains after a drain cycle despite a clean filter and hose, if the pump runs but does not empty, or if the smell persists after a full cleaning and a hot cycle.
Stop if you see mold inside the cabinet or on the insulation behind the tub. That usually means a long-term leak, and the machine needs to come out.
A simple preventive routine that beats every treatment: scrape dishes instead of rinsing, clean the filter monthly, run a hot cycle with vinegar monthly, and leave the door slightly open between uses so the tub dries.
Related reading
If dishes come out dirty, see dishwasher not cleaning. If water is on the floor, see dishwasher leaking water.